Water Jacket for TP Power V2 56mm diameter smooth can motors.
This jacket is designed to fit the TP Power 5650, 5660, 5670 V2 boat motors.
Measures 64mm in diameter x 50mm long.
This Water Cooling Jacket has been designed for maximum heat reduction. At 50mm(1.97") long, the jacket is long enough to cool the motor well. Yet weighs less than 3.0 ounces. We picked high quality aluminum for the jacket to further help with the cooling, as the aluminum acts as a added heat sink. Than we added brass water fittings.
Installation is a snap! Apply some oil/grease to your motor housing and the o-rings on the jacket, than slide on the jacket.
You can identify aTP V2 motor by checking the front and back end plates. The v2 will only have the back end plate screwed on.
The v1 will have both the front and rear end plate screwed on.
Approx. 1.97" (50mm) long x 2.52" (64mm) in diameter.
Not logged in
Help & FAQ
© Copyright 2019 - Offshore Electrics
Unauthorized use of any materials presented here is prohibited. Copying or reproducing any elements from this page is not permitted. All prices, descriptions and availability subject to change.