TFL Scale Outboard with Black Cover (No Graphics Applied)This is the outboard system only. Picture 4 shows this system installed in a TFL Warrior P1 Superstock hull. Picture 5 shows the diagram and parts list. Motor Specs: Motor: TFL SSS 3660 2075 v2 Brushless Motor with 4mm male connectors.- Diameter: 36mm- Connectors: 4mm Female Bullet Connectors - Length: 60mm - Shaft diameter: 5mm Shaft - Includes water jacket. Outboard Specs:- 185mm from the bottom of the skeg to the top of the outboard cover. - The cover is 55mm wide - 550 Grams (approx.) with a brushless motor. - 280 Grams (approx.) without a brushless motor.- Drive Shaft: 4mm Propeller shaft, requires drive dog-style propellers.- Fits up to 48mm Prop- Gear-driven lower unit. Requires: - Everything besides the outboard unit.- Suggested ESC: Raider 150 ESC or Seaking 160 ESC. Both will require you to solder the correct 6mm connectors to the motor. - 2s or 3s maximum, 40c 4000 to 5000mah lipo pack.- Propeller for 4mm prop shaft; the diameter of the prop will depend on the application.- M3 x 6mm or longer (depending on application)Notes:-IMPORTANT: See picture 6 for the screw that needs to be removed to pull out the prop bushing and propeller shaft.-Recommended for 30"(750mm) to 40" (1000mm) hull. The bare hull should be up to 2 pounds. -We recommend no larger than a 36mm diameter x 60mm long motor and a total rpm of 23k or Less. Any higher Kv/larger motor could damage the gear system or other parts.-These are gear-driven and can be used with a left or right-rotation propellers. -Standoff bracket tfl-B54210-14 may be required, depending on the application.
Maintenance Video.
